Document

OSS (OPERATING SYSTEM SOFTWARE) MESSAGES
OS1298 Specified paper tray not present
A command was entered that refers to a feeder tray not in the
printer configuration.
Action Reenter the command, using a feeder tray that your system has.
(Refer to the chapter on feeder trays in your 4635 LPS Operator
Guide.)
OS1300 Number of active forms is nn
The maximum number of forms per print job the system will
attempt to keep in forms memory is (number 0-64). This
message appears at installation when forms memory space is
allocated.
Action None.
OS1310 Number of active fonts is nn
The maximum number of fonts per print job the system will
attempt to keep in memory is (number 0-128). This message
appears at installation when font memory space is allocated.
Action None.
OS1320 Number of active graphics is nn
The maximum number of graphics per print job the system will
attempt to keep in GHO memory is (number 16-128). This
message appears at installation when graphics memory space is
allocated.
Action None.
OS1321 Print darkness level is nn.
After entering the DARKNESS command with a level parameter,
this message tells you that the value you have entered is
accepted. If you enter the DARKNESS command with no
parameters, the message tells you the current level setting.
Action None.
OS1322 Lead edge screen setting is nn
This message confirms that your EDGE (lead edge screen)
command parameters have been accepted or provides you with
the current settings if you have not entered new parameters.
Action None.
OS1323 Energy saver timeout is nn minutes
After entering the ENERGY command with a timeout parameter,
this message tells you that the value you have entered is
accepted. If you enter the ENERGY command with no
parameters, the message tells you the number of minutes
currently set.
Action None.
6-22 XEROX 4635 LASER PRINTING SYSTEM MESSAGE GUIDE