Document

OSS (OPERATING SYSTEM SOFTWARE) MESSAGES
OS1011 Starting diagnostic print job
The system diagnostic interface (SDI) task is involved.
Action None.
OS1012 ALUN$ failed command ignored
The device substitution specified in the SUB DEV command has
failed. Check command and retry.
Action None.
OS1013 Device offline, command ignored
The device substitution specified in the SUB DEV command has
failed. Check command and retry.
Action None.
OS1014 Output cannot be switched--Selected Tray is full
The SELECT or SEPARATE command was entered while the printer
was printing. Output cannot be switched because the entered
stacker tray is full.
The printer control console displays:
OUTPUT TRAY CANNOT BE SWITCHED--SELECTED TRAY IS
FULL
Action 1. Press the <STOP> key or the Stop button on the printer to
halt printing.
2. Unload the full stacker tray.
3. Press the <CON> key to resume printing.
4. Reenter the SELECT or SEPARATE command.
OS1015 ALDN$ failed, command ignored
The device substitution specified in the SUB DEV command has
failed. Check command and retry.
Action None.
OS1016 NT01 or staple not supported
4635 does not support Staple. If Staple is specified in a JDE, JDL
or DJDE, then INPUT will ignore it.
Action None.
OS1017 Physical device %0 substituted for logical device %1.
The device substitution specified in the SUB DEV command has
taken place.
Action None.
OS1020 Job xxxx has completed input phase
All requested manipulation of data is complete and final imaged
pages are in the print file.
Action None.
XEROX 4635 LASER PRINTING SYSTEM MESSAGE GUIDE 6-11