Document

OSS (OPERATING SYSTEM SOFTWARE) MESSAGES
OS0731 Updating the IOT‘S memory with test profile info
FEX is loading into the printer‘s non-volatile memory the new
finishing parameters profile you have specified.
Action None.
OS0732 Finishing exerciser is starting requested print job
FEX has created the test job and is starting to run it.
Action None.
OS0733 Finishing exerciser utility (FEX) starting . . .
The system responds with this message after you have entered
the FEX command.
Action None.
OS0734 Finishing exerciser utility: working . . .
FEX is in communication with the printer.
Note: This message may appear numerous times during the FEX
session.
Action None.
OS0800 NVM update in progress
****DO NOT DISTURB****
The periodic acquisition of information from the printer control
console is in progress.
Action Do not disturb.
OS0801 NVM update complete
The periodic acquisition of information from the printer control
console has been completed.
Action None.
OS0830 Attention Light enabled.
The LIGHT ENABLE command is entered and accepted.
Action None.
OS0831 Attention Light disabled.
The LIGHT DISABLE command is entered and accepted.
Action None.
OS0840 Entering Lockout Mode
The lockout diagnostic mode is active.
Action None.
XEROX 4635 LASER PRINTING SYSTEM MESSAGE GUIDE 6-5