Document

IFU (INTERPRESS FONT UTILITY) MESSAGES
IF7914 IPM input from file x, block y, failed
The system failed in an attempt to read a block from an IPM file.
The file is either corrupted or does not exist on the system.
Action 1. Delete the IPM files on the system.
2. Recompile IPFNTS.SYS to recreate this file.
3. If the problem continues, contact your systems specialist or
Xerox Customer Service.
IF7915 IPM more than 1000 files are needed for x
Allocation is being attempted from the free blocks list but there
are not enough free blocks to store the family. On the one-
thousandth file, this allocation will fail due to file sequence
wraparound.
Action None.
IF7916 IPM package error
IPM would not open. The IPM file is either missing from the
system or is corrupted.
Action 1. Delete the IPM files on the system.
2. Recompile IPFNTS.SYS to recreate this file.
3. If the problem continues, contact your systems specialist or
Xerox Customer Service.
IF7930 Error occurred while reading decomposed FIS file.
A disk input/output error occurred while the system was
accessing an internal temporary file.
Action 1. Reenter the ADD command.
2. If the problem continues, contact your systems specialist or
Xerox Customer Service.
IF7931 Error occurred while accessing the CMT block
An IFU internal error has occurred.
Action None.
IF8101 CMT calling sequence error x
The character mapping table is being processed out of sequence.
Action Contact your systems specialist or Xerox Customer Service.
IF8102 CMT storage request has failed
The amount of storage space requested is too large.
Action Contact your systems specialist or Xerox Customer Service.
IF8103 CMT symbol table has overflowed by map x
There was not enough space in the character mapping table
when adding the next symbol.
Action Contact your systems specialist or Xerox Customer Service.
XEROX 4635 LASER PRINTING SYSTEM MESSAGE GUIDE 5-29