Document

HIP (HOST INTERFACE PROCESSOR) MESSAGES
HP1020 Input report complete - jid xx
This is displayed while in a concatenated job mode if the
concatenated job operator display mode is ON when input
finishes a HIP job.
Action None.
HP1030 Output starting report - jid xx
This is displayed while in concatenated job mode if the
concatenated job operator display mode is ON when output
starts a HIP job.
Action None.
HP1040 Output report complete - jid xx
This is displayed while in a concatenated job mode if the
concatenated job operator display mode is ON when output
finishes a HIP job.
Action None.
HP1100 No jobs to abort
The HIP ABORT command was entered, but the host has not
sent any jobs to the printer.
Action None.
HP1110 End of job display
All job information appears on the system (controller) display.
No more related information will appear at this time.
Action None.
HP1120 HIP job queue cleared
No data remains in the HIP buffer; jobs have printed or have
been aborted.
Action None.
HP1130 Buffer file allocation less than specified
The HIP buffer has less space than specified in the HIP.CMD file
at installation. There may not be enough space to hold the
entire job being sent.
Action 1. Delete unneeded files from system disk to create more
space.
2. Compress the disk. (Refer to your 4635 LPS Operations
Reference chapter on managing LPS resources for additional
information.)
3. Enter SETUP mode to change the HIP buffer file size. (Refer
to your 4635 LPS Operations Reference chapter on HIP-
accessed communicating modes for additional information.)
4. Resend the job.
XEROX 4635 LASER PRINTING SYSTEM MESSAGE GUIDE 4-3