Document

2. DSR (disk save and restore
command) messages
These messages may appear during the process of saving all disk
files on tape or restoring all files to system disk from tape. (Refer
to your 4635 LPS Operations Reference chapter on managing
LPS resources for additional information.)
DS1010 Save process complete
The DSR command was entered. The system has completed
backing-up system disk data on tape.
DS1020 DSR is saving disk drive 0.
DS1030 DSR is saving disk drive 1.
DS1040 DSR is saving disk drive 2.
DS1050 DSR is saving disk drive 3.
Action None.
DS2010 Mount and ready DSR tape
The DSR command was entered when no save tape had been
mounted.
Action Mount the save tape.
DS2020 Mount and ready DSR volume nnnn
The DSR process requires more than one save tape. The system
has encountered the EOV label.
Action Mount the indicated tape volume.
DS3010 Invalid parameter...DSR aborted
An incorrect density parameter was entered with the DSR
command. The DSR task has terminated.
Action Reenter the command as DSR or DSR 6250. No other
parameters are accepted.
DS3020 DSR Version 2.0 unable to run on this configuration
DSR version 2.0 is incompatible with the current printer
configuration.
Action None.
XEROX 4635 LASER PRINTING SYSTEM MESSAGE GUIDE 2-1