Document

OSS (OPERATING SYSTEM SOFTWARE) MESSAGES
OS2004 Paper trays not set for same size
The length guides of the feeder trays are adjusted for different
paper lengths. Automatic switching will not be possible. (This is
an information message appearing at the start of the job.)
The printer control console displays one of the following:
BE SURE BOTH TRAYS CONTAIN THE SAME SIZE PAPER-- PRESS
i
LENGTH GUIDES IN BOTH TRAYS MUST BE ADJUSTED TO THE
SAME SIZE
PAPER TRAYS ARE NOT ADJUSTED TO SAME SIZE--PRESS i FOR
MORE DETAILS
READY TO PRINT--BOTH PAPER TRAYS NOT SET FOR SAME
SIZE--PRESS i
TRAY 1 SET FOR __.__X__.__" PAPER. TRAY 2 SET FOR
__.__ X__.__" PAPER
TRAY 1 SET FOR _X_MM PAPER. TRAY 2 SET FOR _X_MM
PAPER
WARMING UP--BOTH PAPER TRAYS NOT SET FOR SAME SIZE--
PRESS i
Action If tray switching is desired, reset the paper length guides to the
same size. (Refer to the chapter on feeder trays in your 4635 LPS
Operator Guide.)
OS2005 Enter ‘CONTINUE I’ to resume input
or
Select ‘CONTINUE I’ to resume input
The input process was interrupted by the entered command or
error condition. The system is now ready to resume input.
Action Enter the CONTINUE I command to resume interrupted data
transmission.
OS2006 Enter ‘CONTINUE I’ or ‘ABORT I’.
or
Select ‘CONTINUE I’ or ‘ABORT I.’
Input was interrupted due to insufficient file space or a DJDE
processing error. The system is waiting for a command.
Action Enter the CONTINUE I command to resume input. (Some data
may be lost.)
or
Enter the ABORT I command to cancel the job.
OS2007 Empty sample output tray
The sample tray contains more than 100 sheets. It must be
emptied for printing to resume.
The printer control console displays:
EMPTY SAMPLE TRAY
Action Remove output from the sample tray.
6-42 XEROX 4635 LASER PRINTING SYSTEM MESSAGE GUIDE