Document

OSS (OPERATING SYSTEM SOFTWARE) MESSAGES
OS1334 Printer alarm is n, level = n
After entering the ATTENTION ALARM command, this message
tells you whether the alarm is enabled or disabled. If you enter
the ATTENTION ALARM ENABLE command, the message tells you
that the value you requested is accepted or provides the current
setting if you have not included the parameter with the
command.
Action None.
OS1335 XPS Accounting stopped: no disk space for files
XPS is unable to accumulate accounting data because there is no
disk space for files.
Action None.
OS1336 XPS Accounting enabled
XPS received a request from the server to enable accounting.
Action None.
OS1337 XPS Accounting disabled
XPS recieved a request from the server to disable accounting or
HIP was unloaded by entering the HIP END command.
Action None.
OS1342 Currently not in Lockout Mode
This message informs you that the LOCKOUT mode has not
been initiated.
Action None.
OS1380 Alignment is nn Scan Lines and nn Dots
Printed data will appear at the indicated number (76-260) of lines
from the top and bottom edges of paper, and the indicated
number (0-795) of dots from the right and left edges of paper.
Action None.
OS1381 Diagnostic alignment is x Scan lines and y Dots
For Xerox service personnel, this message provides alignment
information.
Action None.
OS1390 Invalid Scan or Dot value. Retry Align
The alignment number entered for dots or lines is not within the
permitted range.
Action Reenter the ALIGN command with value(s) within the range.
(Refer to the problem solving chapter in your 4635 LPS Operator
Guide.)
6-24 XEROX 4635 LASER PRINTING SYSTEM MESSAGE GUIDE