Operation Manual

Scanning with the TWAIN Interface from PaperPort
108 DocuMate 520 Scanner User’s Guide
Setting Up Your Scanner to Work With PaperPort
When you selected a scanning option from the Scanner drop-down
list, such as TWAIN: Xerox DocuMate 520, WIA: Xerox
DocuMate 520, or ISIS: Xerox DocuMate 520, the Scan button at
the bottom of the panel should become active. If it doesn’t, you
need to set up your scanner to work with PaperPort.
NOTE: Setting up your scanner is a one-time-only process for
each option from the Scanner drop-down list. Therefore, you
may have to set up your scanner once each for TWAIN: Xerox
DocuMate 520, WIA: Xerox DocuMate 520, and ISIS: Xerox
DocuMate 520. The setup process, described below, is the
same for each option. You will not have to set up the scanner
again for an option unless you uninstall the scanner and
PaperPort software, then re-install them.
If this Scan button is not active,
you need to set up your scanner.