Operation Manual

Xerox
®
DocuMate
®
4760 Maintenance
34 User Guide
Replacing the Rollers
Frequent paper jams are a symptom of a worn roller assembly. A worn roller can cause documents
to feed in skewed at an angle, or multiple pages to feed at the same time. A worn roller should be
replaced to avoid damage to the scanner’s internal parts. Before replacing the roller you should
clean it as excessive dust on the roller will make it appear worn and smooth. You cannot properly
diagnose a worn roller until you have cleaned it.
Replacing the Separation Roller
The roller will wear out and is designed to be a user-replaceable part. A worn roller can cause
documents to feed in skewed at an angle, or multiple pages to feed at the same time. Before
replacing the roller you should clean it as excessive dust on the roller will make it appear worn and
smooth. You cannot properly diagnose a worn roller until you have cleaned it. You should generally
replace the roller between 80,000 and 100,000 scans.
Replacement parts can be purchased from the Parts & Accessories page for your scanner at
www.xeroxscanners.com
.
1. Lift the ADF cover release, on the top of the scanner, to open the Automatic Document
Feeder cover. The roller module and housing are located in the underside of the ADF cover.
2. Grab the top of the roller housing, just beneath the ADF cover release.