Digital Color Press Operator Manual

DocuColor 5252 Operator Manual
4-9
Paper and Paper Trays
4 Paper and Paper
Trays
Transparency Guidelines
Transparencies can be run ONLY from Tray 3.
• Load transparencies into Tray 3 with the paper stripe side
facing DOWN and with the stripe as the leading edge. (The
leading edge is the edge that feeds into the digital press first.)
• Do not mix paper and transparencies in Tray 3. Jams may
occur.
• Ensure that Transparency is selected in the weight section on
the paper tray.
Use only the transparencies recommended:
• Xerox Removable Paper Stripe: USA and Canada, 3R5765;
Xerox Europe, 3R93179.
Tabbed Inserts
Tabbed Inserts can be loaded into Tray 3 as nonstandard paper.
• When loading, the nontabbed, short edge of the tabbed insert
should be the lead edge to the digital press.
• If a jam occurs while running tabbed sets, there is no recovery
procedure.
• You have to manually reassemble your originals and
prints, determine where the job left off, and resume printing
or cancel the job and start again.
• The size of the tabbed insert should be 9 x 11 inch (229 x 279
mm) for letter size tabs (223.5 x 296 mm for A4 equivalent
tabs).
• The proper weight of the insert should be selected on the
tray.
• Select Non-standard size and input 11 inches or 296 mm for
A4 as the X axis and 9 inches or 223.5 mm for A4 as the Y
axis dimensions for SEF.
Refer to the System Administration Guide (see page 2-42) for the
procedure to program nonstandard size paper.