Installation Guide

COLORWISE PRO TOOLS
25
Installing Device Link Profiles
If you are an administrator, you can download Device Link Profiles to the Fiery EXP8000/50
using Profile Manager. You must associate a Device Link Profile with the following settings:
An RGB Source Profile or a CMYK Simulation Profile setting and
An Output Profile setting
The Device Link Profile is enabled when these two settings are selected.
You can enable a Device Link Profile in three locations:
•In ColorWise Pro Tools Color Setup, select the default settings for RGB Source Profile,
CMYK Simulation Profile, and Output Profile. These settings apply to all jobs unless
overridden for a particular job.
•Use Expert Color Settings in the Fiery EXP8000/50 printer drivers to select the settings
for RGB Source Profile, CMYK Simulation Profile, and Output Profile when you print a
job.
•Use Command WorkStation Job Properties to override the settings for RGB Source
Profile, CMYK Simulation Profile, and Output Profile for a specific job.
For more information about enabling Device Link Profiles using Color Setup, see page 30.
For more information about enabling Device Link Profiles using Expert Color Settings in the
Fiery EXP8000/50 printer driver, see page 89.
TO DOWNLOAD DEVICE LINK PROFILES USING PROFILE MANAGER
1 In Profile Manager, if you do not see the Device Link Profile in the Description list, select the
folder that contains the Device Link Profile by clicking Browse in the upper-left corner.
2 Click OK to add the folder contents to the Description list.
The Device Link Profile is added to the Description list.