Printer Getting Started

36 Installing User Software on a Windows Computer
Use the table below as a guide when installing Downloader and Print Calibrator. For
specific instructions, read the information in each dialog box.
Using the software for the first time
Before you can use the newly installed software, you must properly configure the
connection to the DocuColor 40 CP.
Configuring the connection to the server
The first time you use one of the utilities, you are prompted to configure the
connection to the DocuColor 40 CP.The same configuration is used for Downloader
and Print Calibrator, so any change in the configuration affects both of these.
BEFORE YOU BEGIN:
• Print the Configuration page from the Control Panel and note the IP Address of the
DocuColor 40 CP.
You can also set up a Domain Name Server (DNS) for the IP address of the
DocuColor 40 CP in the printcap file and use that name. See your Windows system
documentation for information.
Name of dialog box: Action: When finished:
Welcome Read the Setup program
introduction.
Click Next.
Choose Destination Location Specify a hard disk location for the
installed utility software.
Click Next.
Select Program Folder Specify a folder name for the utility
software located in the Programs
menu.
Click Next.
Start Copying Files Verify the information in the
Current Settings area.
Click Next.
Information
Acknowledge that the software
installation is complete.
Click OK.