Installation Guide

63 Setting up Fiery WebTools
Fiery WebTools allow you to manage your Fiery XJ remotely from the Internet or from
your company’s intranet. The Fiery XJ has its own home page, from which you are able
to select from a variety of functions including WebSetup, Status, WebSpooler,
WebLink, and Installer.
For more information on using Fiery WebTools, see the Printing Guide and the Job
Management Guide.
Setting up Fiery WebTools
In order for network users to access and use Fiery WebTools, you need to set certain
Fiery XJ options in Setup. You also need to prepare each user’s workstation to
communicate with the Fiery XJ over the Internet or intranet.
For more information about Fiery XJ Setup, see the Configuration Guide.
TO VERIFY THAT FIERY WEBTOOLS ARE SET UP ON THE FIERY XJ:
1. Print the Configuration page from the Control Panel or from the Command
WorkStation.
For instructions, see the Job Management Guide.
2. On the Configuration page, check the following:
• In Network Setup>Port Setup, confirm that the appropriate network type (Ethernet
or Token Ring) is enabled.
• In Network Setup>Protocol Setup>TCP/IP Setup, confirm that TCP/IP is enabled
and that there is a valid, unique IP Address for the Fiery XJ.
• In Network Setup>Service Setup, confirm that Web Services are enabled.
3. If all the conditions listed in Step 2 are currently set, the Fiery XJ is properly set up
to use Fiery WebTools.
If any of the conditions listed in Step 2 are not currently set, you must change them (as
described in the Configuration Guide) before you can use Fiery WebTools.
Downloading
Installers with
Fiery WebTools