Installation Guide

xv System requirements

Parallel port

To print to the Fiery XJ using the parallel port, you need:

• A Windows-based computer with an 80486, AMD, or Pentium processor

• At least 4MB of RAM

• The parallel cable included with the Fiery XJ

The cable has a DB-25 male connector (that connects to the computer) on one end

and a DB-25 female connector (that connects to the Fiery XJ) on the other.

IPX (Novell)

To use the Fiery XJ with an IPX (Novell) network, you need:

• A Novell server

• Novell NetWare software version 4.x or 3.x

• Support for Ethernet SNAP, Ethernet II, Ethernet 802.3, Ethernet 802.2,

Token Ring SNAP, or Token Ring

Command WorkStation

To run the Command WorkStation application from a remote workstation, you need:

• A Windows-based computer with a 200 MHz Pentium processor

• Windows 95

• IPX/SPX or TCP/IP networking protocol installed

• PCI VGA interface card

• At least 32MB of RAM

• At least 2MB of video RAM

• An 850MB IDE or SCSI hard disk drive

•A 2

CD-ROM drive

• A 17" monitor that supports 16-bit color at a minimum resolution of 1024

768