Instruction Manual

Page 3 of 3
©2011 Electronics For Imaging, Inc. Customer Support Release note template v1.2
4 From Command WorkStation, choose Server, Reboot Server, or from the
Fiery LCD, select Shut down, Reboot System.
5 Wait until the Fiery controller reaches Idle and print the configuration page.
6 Verify that the Update Info section contains the patch number 1-1E21N4.
7 NOTE: Do NOT modify any settings or print any jobs until the patch shows up on
the printed configuration page. Since this is a larger composite patch it will take
longer than an individual patch.