Administrator's Guide

Set a value for the dedicated SMB receiving buffer memory capacity from 64 to 1024
KB, in 32 KB increments.
• Memory Spool: When selected, the machine will use spooling. The receiving buffer
for spooling uses memory. When this candidate value is selected, set the memory
capacity of the receiving buffer for spooling from 0.50 MB to 32.00 MB, in 0.25 MB
increments.
Note
Notice that print data exceeding the set memory capacity is not accepted. In such cases,
select Hard Disk or Off.
• Hard Disk Spool: When selected, the machine will use spooling. The receiving buffer
for spooling uses the hard disk.
Receiving Buffer - IPP Spool
• Off: When Off is selected, the machine will not use spooling. While IPP print processing
is being carried out for one client, data cannot be received over the same interface
from another client. Set a value for the dedicated IPP receiving buffer memory
capacity from 64 to 1024 KB, in 32 KB increments.
• Hard Disk: When selected, the machine will use spooling. The receiving buffer for
spooling uses the hard disk.
Receiving Buffer - EtherTalk
Set the EtherTalk receiving buffer. Set a value from 1024 to 2048 KB, in 32 KB increments.
Receiving Buffer - Port 9100
Set the Port9100 receiving buffer. Set a value from 64 to 1024 KB, in 32 KB increments.
Other Settings
Make settings relating to the paper used in the machine.
1. Select System Settings and then Print Service Settings.
2. Select Other Settings.
3. Select the item to be set or changed, and select Change Settings.
4. Select the item to be changed.
5. Select Save.
Substitute Tray
When there is no tray containing the paper size selected by the automatic tray selection,
select whether or not to print replaced with paper loaded in another paper tray. In the
event of using substitute tray, set the size.
• Display Message: Do not use substitute tray, but display a paper loading message.
Xerox
®
D110/D125/D136 Printer5-36
System Administration Guide
System Settings