Administrator's Guide

PostScript Memory
Specify the memory capacity used for PostScript. Set a value from 8.00-96.00 MB, in
0.25 MB increments.
HP-GL/2 Auto Layout Memory
Specify the memory capacity used for HP-GL/2. Set a value from 64-5120 KB, in 32 KB
increments.
Note
The maximum value that can be set for both the PostScript Memory and HP-GL/2 Auto
Layout Memory options vary according to the available memory capacity.
Receiving Buffer - USB
Select a value from 64 KB through 1024 KB.
Receiving Buffer - LPD
• Off: When Off is selected, the machine will not use spooling. During the LPD print
process for one client, data cannot be received over that same interface from a
different client. Set a value for the dedicated LPD receiving buffer memory capacity
from 1024-2048 KB, in 32 KB increments.
• Memory Spool: When selected, the machine will use spooling. The receiving buffer
for spooling uses memory. When this candidate value is selected, set the memory
capacity of the receiving buffer for spooling, from 0.50 MB to 32.00 MB, in 0.25 MB
increments.
Note
Notice that print data exceeding the set memory capacity is not accepted. In such cases,
select Hard Disk or Off.
• Hard Disk Spool: When selected, the machine will use spooling. The receiving buffer
for spooling uses the hard disk.
Receiving Buffer - NetWare
Set the NetWare receiving buffer. Set a value from 64 to 1024 KB, in 32 KB increments.
Receiving Buffer - SMB Spool
• Off: When Off is selected, the machine will not use spooling. While SMB print
processing is being carried out for one client, data cannot be received over the same
interface from another client.
5-35Xerox
®
D110/D125/D136 Printer
System Administration Guide
System Settings