User's Manual

Radio frequency emissions
FCC in the USA
This equipment has been tested and found to comply with the limits for a Class A digital
device, pursuant to Part 15 of the Federal Communications Commission (FCC) Rules.
These limits are designed to provide reasonable protection against harmful interference
when the equipment is operated in a commercial environment. This equipment generates,
uses, and can radiate radio frequency energy and, if not installed and used in accordance
with the instruction manual, may cause harmful interference to radio communications.
Operation of this equipment in a residential area is likely to cause harmful interference
in which case the user will be required to correct the interference at his/her own expense.
Changes or modifications to this equipment not specifically approved by the Xerox
Corporation may void the user’s authority to operate this equipment.
Warning
Shielded cables must be used with this equipment to maintain compliance with FCC
regulations.
In Canada (ICES-003)
This Class “A” digital apparatus complies with Canadian ICES-003.
Cet appareil numérique de la classe “A” est conforme à la norme NMB-003 du Canada.
Regulatory information for RFID
This product generates 13.56 MHz using an Inductive Loop System as a Radio Frequency
Identification system device (RFID). This RFID device complies with the requirements
specified in FCC Part 15, Industry Canada RSS-210, European Council Directive 99/5/EC,
and all applicable local laws and regulations.
Operation of this device is subject to the following two conditions: 1) this device may
not cause harmful interference, and 2) this device must accept any interference received,
including interference that may cause undesired operation.
Changes or modifications to this equipment not specifically approved by Xerox
Corporation may void the user’s authority to operate this equipment.
Xerox
®
D95/D110/D125/D1361-2
Safety Guide
Notices and certifications