Installation Guide

Smart Card Installation
Installation and Configuration Guide 35
Using Smart Card
Once the Smart Card has been enabled, each user must insert a valid card and enter their Personal Identification
Number (PIN) on the touch screen. When a user has finished using the Xerox® device, they are then required to
remove their card from the card reader to end the session. For instances where a user forgets to remove their card,
the machine will end the session automatically after a specified period of inactivity.
Follow the instructions below to use the Smart Card:
1. The Authentication Required window may be displayed on the touch screen, depending on your device
configuration.
2. Insert your card into the card reader.
3. Use the touch screen and numeric keypad to enter your PIN and then select Enter.
4. If the card and PIN are authenticated, access is granted.
Note: If the access attempt fails, refer to Troubleshooting Tips on page 39.
5. Complete the job.
6. To end the session, remove your card from the card reader.
The current session is terminated and the Authentication Required window is displayed.