Installation Guide

Installation Smart Card

Installation and Configuration Guide20

Configuring the Smart Card

Once the Smart Card feature has been enabled on the device it can be configured using Internet Services.

Configure Smart Card Authentication

Follow the instructions below to enable and configure the Smart Card:

1. In the Internet Services

ensure you have the Login Methods link

selected.

2. Enter the Domain Controller details for

the authentication server.

a. Select Domain Controller(s) - Edit

from the Configuration Settings list.

Note: Initially the Domain Controller(s) will

be empty and the NTP server will not be

set.

b. Select Add Domain Controller.

c. Select Windows Based Domain

Controller or leave this box

unchecked to select Linux Based

Domain Controller.

d. Select either IP Address or Host

Name and enter the Domain

Controller details. If you enter the

Host Name, this must be the fully

qualified Host Name.

e. Ensure Port 88 is selected unless your Kerberos Port is different.

f. Enter the Domain (this must be the fully qualified Domain Name).

g. Select Save.