User's Manual

CQ8700-8900
Customer Support Page 14
Formatting Commands
Feed Edge
The values indicate the feed edge to use. Feeds paper so that Leading Edge of paper is the shorter side.
PJL COMMENT Command DSC Comment Command PS
@PJL COMMENT
OID_ATT_FEED_EDGE string;
%% OID_ATT_FEED_EDGE
string;
<< /Leading Edge int >>
setpagedevice
Where string is:
OID_VAL_FEED_EDGE_SHORT_LEADING
OID_VAL_FEED_EDGE_SHORT_TRAILING
OID_VAL_FEED_EDGE_LONG_LEADING
OID_VAL_FEED_EDGE_LONG_TRAILING
null = use default orientation for
specified /PageSize to select which
edge is the top of the page.
0 = Short edge, leading edge is the
top of the page.
2 = Short edge, trailing edge is the
top of the page.
Simplex / Duplex Printing
This command specifies if a job is to print on one side or both sides of the sheet. Choose one of the methods below for
indicating this feature.
Simplex/Duplex PS PCL5 PJL
one-sided << /Duplex false /Tumble false >>
setpagedevice
<Esc>&l0S @PJL SET DUPLEX=OFF
two-sided long-
edge
<< /Duplex true /Tumble false >>
setpagedevice
<Esc>&l1S @PJL SET DUPLEX= ON
@PJL SET BINDING= LONGEDGE
two-sided short-
edge
<< /Duplex true /Tumble true >>
setpagedevice
<Esc>&l2S @PJL SET DUPLEX= ON
@PJL SET BINDING= SHORTEDGE
Finishing Commands
Offset
This feature provides a physical offset of hard copy that distinguishes between sets or stacks within a job.
PJL PS
@PJL SET JOBOFFSET=string << /Jog int >> setpagedevice
Where string is ON or OFF Where int is:
0 = no offset
3 = offset each set