User's Manual

Maintenance
168 ColorQube 8700/8900 Color Multifunction Printer
User Guide
3. To clean the pick roller, lay a strip of clear packing tape on a table, sticky side up. Run the pick roller
assembly along the length of the tape.
Note: Do not use masking tape or duct tape because they can leave residue on the roller.
4. Reinstall the pick roller assembly.
a. Hold the pick roller assembly vertically so that it aligns with the spaces into which it fits.
b. Gently snap the assembly into the slots. The assembly hangs down in the same position it was
in when you pulled it out of the printer in step 2d.
c. Gently swing the pick roller assembly up until clicks in place.
5. Reinstall the separator roller assembly. Squeeze in the two outer tabs and push the assembly
straight into the opening until both ends click in place.