User's Manual

Xerox® Smart Card
Installation Guide
5
1
Introduction
The Xerox Smart Card solution brings an advanced level of security to sensitive information.
Organizations can restrict access to the walk-up features of a Xerox device. This ensures only
authorized users are able to copy, scan, e-mail and fax information.
The key benefit of this solution is its two-factor identification requirement. Users must insert their
access card and enter a unique Personal Identification Number (PIN) at the device. This provides
added security in the event that a card is lost or stolen.
Once validated, a user is logged into the Xerox device for all walk-up features. The system allows for
functions to be tracked for an added layer of security.
The Xerox Smart Card enablement kit integrates with Xerox multifunction printers and existing smart
and personal identity verification cards and readers.
This guide explains how to install and configure the Smart Card solution. It identifies the resources and
equipment required to complete a successful installation.
Should you require any further information, please contact your Local Xerox Representative.
Compatibility
This solution is compatible with the following configuration:
• To identify the software level on your machine, press the Machine Status button on the control
panel.
• The System Software Version number is displayed.
Configuration Software Level CAC PIV .NET
ColorQube™ 8700
and ColorQube
™
8900
071.160.222.26600 or lower
Note: If your System Software Version is
071.160.222.26601 or higher, please refer to the Xerox
Smart Card Installation and Configuration Guide for
Xerox ColorQube™ 8700/8900 with System Software
Version 071.160.222.26601 or higher.
Yes Yes Yes