User's Manual

In-Line Process Controls
Automatic. Routine. Accurate.
Process Control “ProCon” is the in-line process by
which CMYK patches are laid down on the IBT
(Intermediate Belt Transfer) and read via internal
sensors throughout a print run. The number of patches
and frequency is optimized for speed and quality.
The end-user may be unaware of the automatic, routine
density checks in a print run—You may see “Adjusting
Image Quality” flashed on the top of the C60/C70 User
Interface.
.
Automatic Sensor Adjustments: (TRC)
• 13%,30%,45%,60%,75%, 100% patches
for CMY
• 15%,30%,50%, 100% patches for Black
Real Time Run Control Patches
• Startup/Power and after 4 hours of
inactivity, Temperature and humidity
change
• When the fuser area is opened and
closed,
• When changing from Uncoated to Coated
stock
During Print Runs (no interruption)
• Two color patches at a time (C and K, Y
and M, colors in station 1 and 2) are
developed in the inter-image area and
read by the In and Out ADC Sensors to
make slight changes on the fly:
An 75% patch for Color (devbias)
An 50% patch for Black (devbias)
Process Controls are run automatically
by the C60/C70—Before, During and
After Printing