User's Manual

About the Output Tab
The Output tab enables you to configure finishing options. Finishing is a general term
that refers to the processes that are typically performed on a job after it is printed. The
specific finishing options that are available vary based on the capabilities of your printer
and any attached finishing units. If no finishing unit is available, the default setting is
None.
From the Output window you can configure the following basic printing properties:
• Stapling/Finishing
• Sides Imaged
• Output Location
• Offset
• Collation
• Output Delivery
• Collated Sets Offset Interval
• Output Order
• Slip Sheets
• Slip Sheets Stock
When you are finished making selections, click either:
• Cancel to exit the window without saving your selections
• Save to save your selections and close the window
About Stapling/Finishing
Select the desired option for stapling, hole punching, and/or folding.
Note
Depending on your selections, additional Stapling and/or Hole Punch menus or options
may appear where you can make additional selections.
Note
The graphical representation of the printed pages is updated to show the results of the
options selected.
About Sides Imaged
This option determines the placement and positioning of the image or text on the page.
• 1 Sided: Only the front side of the sheet of paper is printed.
• 2-Sided: Both the front and the back sides of the paper are printed.
FreeFlow Print Server4-20
Online Help
Queue Manager