User's Guide Color Laser Printer C55/C55mp
Table Of Contents
- Xerox DocuPrint C55/C55mp Color Laser Printer User’s Guide
- Table of Contents
- Chapter 1: Introduction
- Chapter 2: Introduction to Your C55 Printer
- Chapter 3: Print Media
- Chapter 4: The Control Panel
- Chapter 5: Special C55 Printer Driver Options
- Chapter 6: Troubleshooting
- Chapter 7: Printer Maintenance
- Chapter 8: Optional Equipment
- Chapter 9: Network Printer Services
- Appendix A: Safety Notes
- Appendix B: Special Notices
- Appendix C: Printer Technical Specifications
- Index
- Table of Contents
- CHAPTER1.PDF
- Introduction
- What Is In This Guide
- Chapter 1: Introduction
- Chapter 2: Introduction to Your C55 Printer
- Chapter 3: Print Media
- Chapter 4: The Control Panel
- Chapter 5: Xerox Printer Driver Options
- Chapter 6: Troubleshooting
- Chapter 7: Printer Maintenance
- Chapter 8: Optional Equipment
- Chapter 9: Network Printer Services
- Appendix A: Safety Notes
- Appendix B: Special Notices
- Appendix C: Printer Technical
- Index
- Conventions Used
- Where To Go For More Information
- What Is In This Guide
- Introduction
- CHAPTER2.PDF
- CHAPTER3.PDF
- CHAPTER4.PDF
- CHAPTER5.PDF
- Special C55 Printer Driver Options
- PostScript vs. PCL 5C Printer Driver Feature Comparison
- PCL 5C Printer Driver Features
- PostScript Printer Driver Features
- ImageFix (Windows 95 PostScript only)
- Special C55 Printer Driver Options
- CHAPTER6.PDF
- CHAPTER7.PDF
- CHAPTER8.PDF
- CHAPTER9.PDF
- CHAPTERA.PDF
- CHAPTERB.PDF
- CHAPTERC.PDF
- INDEX.PDF

T R O U B L E S H O O T I N G 6–21
Table 6–2: Print Defects and Potential Remedies (continued)
Print Defect Common Causes Potential Remedies
Repeating Defects–
Marks that recur
uniformly:
1. Once every page
2. Every 3.5 inches
(89mm)
3. Every 2.5 inches
(64mm)
1. The Print Drum is
scratched or damaged.
2. - Toner on the Fuser
Rollers.
- There is not enough
oil on the Fuser rollers.
- The Fuser cleaner is
improperly installed.
3. There is toner on the
Grounding Roller.
1. Remove and inspect
the Print Drum.
Replace it if a scratch
or damage is visible.
2. - Clean the Fuser
rollers. Run a blank
sheet of paper through
the printer to clean up
any residual toner.
- Replace the Fuser
Oil Bottle.
- Reinstall the Fuser
cleaner assembly.
3. Clean the Grounding
Roller (see page 7-9).
Print Defect Common Causes Potential Remedies
Back-Side
Contamination–
Toner that has been
deposited on the non-
imaged side of the prints
Toner on the Fuser
Rollers.
There is not enough oil on
the Fuser rollers.
The Fuser cleaner is
improperly installed.
There is dirt in the paper
path.
Clean the Fuser rollers.
Run a blank sheet of
paper through the printer
to clean up any residual
toner.
Replace the Fuser Oil
Bottle.
Reinstall the Fuser
cleaner assembly.
Clean the paper path. See
“Chapter 7: Printer
Maintenance.”