User's Manual

Table Of Contents

• An IP address that is configured properly for your network

• The Network Mask address

• The default Router/Gateway address

If you are on a network managed by a network administrator, contact your network administrator to

obtain the network information.

For a home network using routers or other devices to connect the printer to the network, refer to the

device instructions on assigning network addresses. The router or device documentation can give you

a range of acceptable address numbers you can use. It is important that the addresses be similar to

the IP addresses used by other printers and computers on the network, but not the same. Only the

last digit must be different. For example, your printer can have the IPv4 address 192.168.1.2 while

your computer has the IP address 192.168.1.3. Another device can have the IP address 192.168.1.4.

The router can assign the static IP address of the printer to another computer that obtains its IP

address dynamically. To avoid having the IP address reassigned, provide the printer an address at the

higher end of the range allowed by the device. For example, if your computer has IP address

192.168.1.2, and your device allows IP addresses to 192.168.1.255, select an address between

192.168.1.200 and 192.168.1.254. If your computer has an IP address of 192.168.1.100 or higher,

select an address between 192.168.1.2 and 192.168.1.50.

Note: It is recommended when setting a static IP address, that at the same time, you set a

DHCP reservation. For details, refer to your router documentation.

In IPv6 network configurations, the IPv6 address is assigned automatically.

For reference:

Online Support Assistant at: www.xerox.com/office/support, then select your specific printer model.

Xerox

VersaLink

Series Multifunction and Single Function Printers

System Administrator Guide

Initial Setup