User Manual

Table Of Contents
Networking
CCoonnnneeccttiinngg tthhee PPrriinntteerr ttoo aa WWii--FFii NNeettwwoorrkk
Note: This feature is available only in some printer models.
Before you begin, make sure that:
Active Adapter is set to Auto. From the control panel, navigate to Settings > Network/Ports >
Network Overview > Active Adapter.
For non-touch-screen printer models, to navigate through the settings, press OK.
The Ethernet cable is not connected to the printer.
UUssiinngg tthhee wwiirreelleessss sseettuupp wwiizzaarrdd iinn tthhee pprriinntteerr
Before using the wizard, make sure that the printer firmware is updated. For more information, see
Updating Firmware.
1. From the home screen, touch > Set up now.
2. Select a Wi-Fi network, and then type the network password.
3. Touch Done.
UUssiinngg tthhee SSeettttiinnggss MMeennuu iinn tthhee PPrriinntteerr
1. From the home screen, touch Settings > Network/Ports > Wireless > Setup On Printer Panel >
Choose Network.
2. Select a Wi-Fi network, then type the network password.
Note: For Wi-Fi-network-ready printer models, a prompt to set up the Wi-Fi network appears
during initial setup.
CCoonnnneeccttiinngg tthhee PPrriinntteerr ttoo aa WWiirreelleessss NNeettwwoorrkk UUssiinngg
WWii--FFii PPrrootteecctteedd SSeettuupp ((WWPPSS))
Note: This feature is available only in some printer models.
Before you begin, make sure that:
The access point (wireless router) is WPS-certified or WPS-compatible. For more information, see
the documentation that came with your access point.
A wireless network adapter is installed in your printer. For more information, see the instructions
that came with the adapter.
Active Adapter is set to Auto. From the control panel, navigate to: Settings > Network/Ports >
Network Overview > Active Adapter.
For non-touch-screen printer models, press OK to navigate through the settings.
Xerox
®
C230 Color Printer
User Guide
45
Set up, install, and configure