User's Manual
Table Of Contents
- Safety
- Getting Started
- Installation and Setup
- Using the Services
- Printing
- Paper and Media
- Maintenance
- Troubleshooting
- Troubleshooting Overview
- General Troubleshooting
- Restarting the Printer
- Printer Fails to Power On
- Printer Resets or Powers Off Frequently
- Document Prints from the Wrong Tray
- Automatic 2-Sided Printing Problems
- Paper Tray Fails to Close
- Printing Takes Too Long
- Print Job Fails to Print
- Printer Makes Unusual Noises
- Condensation has Formed Inside the Printer
- Paper Curl
- Paper Jams
- Printing Problems
- Print-Quality Problems
- Copy and Scan Problems
- Fax Problems
- Getting Help
- Security
- Xerox® CentreWare® Internet Services
- Setting Access Rights
- Setting Print Permissions
- Device User Database
- Secure HTTP
- IP Filtering
- IPSec
- Security Certificates
- Concealing or Showing Job Names
- 802.1x
- Displaying or Hiding Network Settings
- System Timeout
- USB Port Security
- Restricting Access to the Web User Interface
- Software Verification Test
- Specifications
- Regulatory Information
- Recycling and Disposal
Supported Paper
Xerox
®
B215 Multifunction Printer
User Guide
180
Supported Paper
Your printer is designed to use various paper and other media types. To ensure the best print quality
and to avoid jams, follow the guidelines in this section. For best results, use Xerox paper and media
recommended for your printer.
Ordering Paper
To order paper or other media, contact your local reseller or visit www.xerox.com/office/supplies.
General Paper Loading Guidelines
• Do not overfill the paper trays. When loading paper, do not fill above the Maximum Fill line
indicated by the symbol .
• Adjust the paper guides to fit the paper size.
• Fan paper before loading it in the paper tray.
• If excessive jams occur, use paper or other approved media from a new package.
• Use only paper envelopes. Print envelopes 1-sided only.
• Always use paper and other media that conforms to the specifications.
• Only use the special media recommended for use in laser printers.
• To prevent special media such as transparencies and label sheets from sticking together, remove
them from the exit tray as they are printed.
• Place transparencies on a flat surface after removing them from the printer.
• Do not leave special media in the manual feed slot for long periods of time. Dust and dirt may
accumulate on them resulting in spotty printing.
• To avoid smudging caused by fingerprints, handle transparencies carefully.
• To avoid fading, do not expose the printed transparencies to prolonged sunlight.
• Verify that your labels’ adhesive material can tolerate fusing temperature of 200
o
C (392
o
F) for 0.1
second.
• Ensure that there is no exposed adhesive material between labels.
CAUTION: Exposed areas can cause labels to peel off during printing, which can cause paper
jams. Exposed adhesive can also cause damage to printer components.
• Do not feed a sheet of labels through the printer more than once. The adhesive backing is
designed for one pass only through the printer.
• Do not use labels that are separating from the backing sheet or are wrinkled, bubbled, or
otherwise damaged.