Manual

8825/8830 Controller Setup Manual for Firmware 6.0 30
Controller Overview (continued)
Preparing The 10/100 Ethernet Port
Overview
This port is standard on the all Controllers.
To print using this port your workstation must have a Network Interface Card
installed, protocols enabled, and appropriate software running.
Enable Controller Ethernet Port
Use the Setup I/O Ports menu of the Printer Control Panel to set the Ethernet
“Port Enable” to “ADVANCED.”
Refer to your Network Administrator or the 8825/8830/8855 Network
Administrator's Guide (available at www.xes.com) for additional information.
Network Protocols Supported:
TCP/IP
• lpr/lpd
• tftp and ftp
Software Supported:
WINDOWS 95/98 PLATFORM:
• HP-GL/2/RTL Print Driver
• ADI Driver for AutoCAD R13/14
• HDI Driver for AutoCAD 2000 and 2000i
• PostScript PPD System Print Driver
• Web Printer Manager Tool (Administration and Job Queue Management)
• AccXES Client Tools
• Web PMT (requires Firmware 4.0 release or higher)
WINDOWS 4.0 & 2000 PLATFORMS:
• HP-GL/2/RTL Print Driver
• ADI Driver for AutoCAD R13/14
• HDI Driver for AutoCAD 2000 and 2000i
• PostScript PPD System Print Driver
• AccXES Client Tools
• Web PMT (requires Firmware 4.0 release or higher)
UNIX PLATFORM:
• Web PMT (requires Firmware 4.0 release or higher)
• tftp puts and ftp
• lpr/lpd support
• AccXES Client Tools (Solaris)