Manual

8825/8830 Controller Setup Manual for Firmware 6.0 27
Controller Overview (continued)
Preparing The 3003-XTP NIC Ethernet
Port
Ethernet Port (Legacy NIC for N5T Controller)
The optional, 3003-XTP Network Interface Card (NIC) provides connectivity
to two standard Ethernet type networks. 10Base2 (BNC Thinnet) and
10BaseT (Twisted Pair RJ-45) connectors are both available and the NIC
auto-senses the active connector.
To print using this port your workstation must have a Network Interface card
installed, protocols enabled, and appropriate software running. For complete
setup details see the 8825/8830/8855 Network Administrator’s Guide
available on the Internet at www.xes.com.
Note: All Controllers now use an optional, external Ethernet adapter
attached to the Controller's parallel port, to support TCP/IP, IPX/SPX, and
NetBEUI protocols. Contact your XES sales or service representative for
specific ordering and setup information.
Enabling the Controller Ethernet Port
Use the Setup I/O Ports menu of the Printer Control Panel to set the Ethernet
“Port Enable” to PRINTER, and set a protocol compatible with your network.
Refer to your Network Administrator or the 8825/8830/8855 Network
Administrator's Guide (available at www.xes.com) for additional information.
NETWORK PROTOCOLS SUPPORTED
TCP/IP
• lpr/lpd
• TFTP
• Telnet
Dynamic Host Configuration via:
− DHCP
− RARP/BOOTP
Novell NetWare (IPX/SPX)
Auto sensing of frame types:
• Ethernet 2, Ethernet SNAP, 802.2, and 802.3
• Bindery mode
• NDS mode
EtherTalk
Phase I and Phase II
NetBEUI
Native MS NetBEUI