Manual

8825/8830 Controller Setup Manual for Firmware 6.0 26
Controller Overview (continued)
Preparing the Host Ultra SCSI Port
Ultra SCSI Port (Host)
To use this port your workstation must have a SCSI interface card and
appropriate software installed and operating. An optional card is also
required for use with the 8825 EV4 Controller.
Enable Controller SCSI Port
Use the Setup I/O Ports menu of the Printer Control Panel to enable the port
and set a device number compatible with your workstation. By default, the
host SCSI port bus termination is enabled.
Network Protocols Supported
Does not apply to the SCSI-2 port.
Software Supported
• ServeWare Version 2.42 or later.
• VGS (in Xerox 150 Emulation Mode)
Data Formats Supported
• Xerox 150 Emulation
• Versatec Raw Raster
• VDS
• VCGL
SCSI Cable Description
The SCSI-2 cable must not exceed a maximum length of 9.75 feet (3
meters).
Ultra SCSI Connector Pin Outs (host)
Pin
Numbe
r
Signal
Name
Pin
Numbe
r
Signal
Name
Pin
Numbe
r
Signal
Name
1 GROUND 18 GROUND 35 GROUND
2 GROUND 19 GROUND 36 GROUND
3 GROUND 20 GROUND 37 No Connect
4 GROUND 21 GROUND 38 SATRMPW
R
5 GROUND 22 GROUND 39 No Connect
6 GROUND 23 GROUND 40 GROUND
7 GROUND 24 GROUND 41 SAATN*
8 GROUND 25 GROUND 42 GROUND
9 GROUND 26 SADB0* 43 SABSY*
10 GROUND 27 SADB1* 44 SAACK*
11 GROUND 28 SADB2* 45 SARST*
12 No Connect 29 SADB3* 46 SAMSG*
13 No Connect 30 SADB4* 47 SASEL*
14 No Connect 31 SADB5* 48 SACD*
15 GROUND 32 SADB6* 49 SAREQ*
16 GROUND 33 SADB7* 50 SAIO*
17 GROUND 34 SADBP*