Manual

8825/8830 Controller Setup Manual for Firmware 6.0 25
Controller Overview (continued)
Preparing The VPI Port
VPI Port
To use the VPI port requires a workstation with a VPI interface card and
appropriate software. An optional card is also required for use with the 8825
EV4 Controller.
Enable Controller VPI Port
Use the Setup I/O Ports menu of the Printer Control Panel to enable the VPI
port.
Network Protocols Supported
Does not apply to the VPI port.
Software Supported
• ServeWare
• VGS (in Xerox 150 Emulation Mode)
Data Formats Supported
• Xerox 150 Emulation
• Versatec Raw Raster
• VDS
• VCGL
VPI Cable Description
The maximum length of a VPI cable must not exceed 1000 feet (304.8 m).
VPI Connector Pin Out
Connector
Pin Number
Signal Name Connector
Pin Number
Signal Name
1 IN01+ 20 IN01-
2 IN02+ 21 IN02-
3 IN03+ 22 IN03-
4 IN04+ 23 IN04-
5 IN05+ 24 IN05-
6 IN06+ 25 IN06-
7 IN07+ 26 IN07-
8 IN08+ 27 IN08-
9 RCLEAR- 28 RCLEAR+
10 PICLK+ 29 PICLK-
11 READY- 30 READY+
12 PRINT+ 31 PRINT-
13 No Connect 32 INOP-
14 RSPP- 33 RSPP+
15 RESET- 34 RESET+
16 RFFED- 35 RFFED+
17 REOT- 36 REOT+
18 RLTER- 37 RLTER+
19 INOP+