User guide
Table Of Contents
- Contents
- Printer Features
- Network Basics
- Printing Basics
- Print Quality
- Controlling the Quality of Your Prints
- Solving Print-Quality Problems
- Light Lines or Streaks in One Color
- Dark Lines, Smudges, or Streaks Through All Colors
- Repeating Defects
- Colors Align Incorrectly
- Incomplete Fusing
- Image Is Offset
- Solid Fills Appear Mottled or Blotchy, Blacks Appear Blue
- Poor Transparency Print Quality
- All Colors Are Too Light or Too Dark
- Grays Are Not Neutral
- Colors Vary Between Computers
- Colors Do Not Match
- Printed Colors Do Not Match Monitor Colors
- PANTONE Colors Do Not Match
- Color Settings Not Applied
- Print Area Is Not Centered on the Paper
- Maintenance
- Troubleshooting
- User Safety
- Index
Solving Print-Quality Problems
Phaser® 7760 Color Laser Printer
4-10
Incomplete Fusing
Problem
Solution
1. Verify that the paper you are using is the correct type for the printer. See Supported Paper
and Media on page 3-3.
2. Verify that the paper is properly loaded in the tray, and the correct paper type is selected in
the
Paper Tray Setup menu. See Loading Paper on page 3-9.
If the problem continues:
1. Do one of the following:
■ Tray 1 (MPT): Remove and re-insert the paper.
■ Tray 2-5: Open and close the selected paper tray. The control panel prompts you to
confirm or change the paper type.
2. On the control panel, select
Change, press the OK button, and then do one of the
following:
■ Select the correct paper type, and then press the OK button.
■ Select the next heavier type of paper, and then press the OK button.
Note: Paper types from lightest to heaviest are: Plain Paper, Heavy Plain Paper, Thin Card
Stock, Thick Card Stock, Extra Thick Card Stock.
Toner appears to be missing from the print, or rubs off easily.