User guide
Table Of Contents
- Contents
- Printer Features
- Network Basics
- Printing Basics
- Print Quality
- Controlling the Quality of Your Prints
- Solving Print-Quality Problems
- Light Lines or Streaks in One Color
- Dark Lines, Smudges, or Streaks Through All Colors
- Repeating Defects
- Colors Align Incorrectly
- Incomplete Fusing
- Image Is Offset
- Solid Fills Appear Mottled or Blotchy, Blacks Appear Blue
- Poor Transparency Print Quality
- All Colors Are Too Light or Too Dark
- Grays Are Not Neutral
- Colors Vary Between Computers
- Colors Do Not Match
- Printed Colors Do Not Match Monitor Colors
- PANTONE Colors Do Not Match
- Color Settings Not Applied
- Print Area Is Not Centered on the Paper
- Maintenance
- Troubleshooting
- User Safety
- Index
Printing on Specialty Media
Phaser® 7760 Color Laser Printer
3-33
Printing on Specialty Media
This section includes:
■ Printing Transparencies on page 3-33
■ Printing Envelopes on page 3-36
■ Printing Labels on page 3-38
■ Printing Glossy Paper on page 3-40
■ Printing Custom Size Paper on page 3-45
Printing Transparencies
Transparencies can be printed from Tray 1 (MPT) and Tray 2. They should be printed on one
side only.
For best results, use only Xerox Digital Color Clear Transparency Film. For more information,
see the Recommended Media List at www.xerox.com/paper
.
To order paper, transparencies, or other specialty media, contact your local reseller or go to
www.xerox.com/office/supplies
.
Caution: Damage caused by using unsupported paper, transparencies, and other specialty
media is not covered by the Xerox warranty, service agreement, or Total Satisfaction
Guarantee. The Total Satisfaction Guarantee is available in the United States and Canada.
Coverage may vary outside these areas; please contact your local representative for details.
Guidelines
■ Remove all paper before loading transparencies in the tray.
■ Do not load more than 50 transparencies in Tray 1 (MPT). Do not load more than
200 transparencies in Tray 2. Overloading the tray may cause the printer to jam.
■ Handle transparencies by the edges using both hands to avoid fingerprints and creases,
which can cause poor print quality.
■ After loading the transparencies in the tray, use the control panel to change the paper
type to
Xerox Transparency.