User guide
Table Of Contents
- Contents
- Printer Features
- Network Basics
- Printing Basics
- Print Quality
- Controlling the Quality of Your Prints
- Solving Print-Quality Problems
- Light Lines or Streaks in One Color
- Dark Lines, Smudges, or Streaks Through All Colors
- Repeating Defects
- Colors Align Incorrectly
- Incomplete Fusing
- Image Is Offset
- Solid Fills Appear Mottled or Blotchy, Blacks Appear Blue
- Poor Transparency Print Quality
- All Colors Are Too Light or Too Dark
- Grays Are Not Neutral
- Colors Vary Between Computers
- Colors Do Not Match
- Printed Colors Do Not Match Monitor Colors
- PANTONE Colors Do Not Match
- Color Settings Not Applied
- Print Area Is Not Centered on the Paper
- Maintenance
- Troubleshooting
- User Safety
- Index
Solving Print-Quality Problems
Phaser® 7760 Color Laser Printer
4-17
Print Area Is Not Centered on the Paper
Problem
The printed area appears outside the margins on the page.
Solution
1. On the control panel, select Paper Tray Setup, and then press the OK button.
2. Select the tray you are using, and then press the OK button.
3. Verify that the tray is set to the correct paper size.
4. If the problem continues, use the Calibrate Margins page to shift the print area on the
paper. The print area appears as a dashed rectangle on the Calibrate Margins page; the
printer does not print outside this rectangle.
a. On the control panel, select
Troubleshooting, and then press the OK button.
b. Select
Print Quality Problems, and then press the OK button.
c. Select
Calibrate Margins, and then press the OK button.
d. Select
Calibrate Margins Page, and then press the OK button.
e. Select the appropriate tray to calibrate, and then press the OK button.
f. Follow the instructions on the Calibrate Margins page.
See also:
Advanced Features Guide at www.xerox.com/office/7760support