User guide
Table Of Contents
- Contents
- Printer Features
- Network Basics
- Printing Basics
- Print Quality
- Controlling the Quality of Your Prints
- Solving Print-Quality Problems
- Light Lines or Streaks in One Color
- Dark Lines, Smudges, or Streaks Through All Colors
- Repeating Defects
- Colors Align Incorrectly
- Incomplete Fusing
- Image Is Offset
- Solid Fills Appear Mottled or Blotchy, Blacks Appear Blue
- Poor Transparency Print Quality
- All Colors Are Too Light or Too Dark
- Grays Are Not Neutral
- Colors Vary Between Computers
- Colors Do Not Match
- Printed Colors Do Not Match Monitor Colors
- PANTONE Colors Do Not Match
- Color Settings Not Applied
- Print Area Is Not Centered on the Paper
- Maintenance
- Troubleshooting
- User Safety
- Index
Solving Print-Quality Problems
Phaser® 7760 Color Laser Printer
4-13
Poor Transparency Print Quality
Problem
Print-quality defects are occurring on the transparency film:
■ Light and/or dark spots.
■ Smeared toner
■ Light bands on the print
Caution: Damage caused by using unsupported paper, transparencies, and other specialty
media is not covered by the Xerox warranty, service agreement, or Total Satisfaction
Guarantee. The Total Satisfaction Guarantee is available in the United States and Canada.
Coverage may vary outside these areas; please contact your local representative for details.
To order paper, transparencies, or other specialty media, contact your local reseller or go to
www.xerox.com/office/supplies
.
Solution
1. Using non-recommended transparency film can cause print-quality problems or damage
the printer’s fuser. See the Recommended Media List at www.xerox.com/paper
.
2. Verify that the paper is properly loaded in the tray, and that
Transparency is the selected
paper type in the
Paper Tray Setup menu. See Loading Paper on page 3-9.