User's Manual

– To activate a transmit key, click Transmit Key.
– For each Transmit Key that you select, type values into the corresponding fields.
• For both WPA2 Personal and Mixed Mode Personal, type the network passcode in the Passcode
field and the Retype Passcode field.
• For both WPA2 Enterprise and Mixed Mode Enterprise:
– Click Authentication Method, then select the authentication method for your wireless
network.
– For Root Certificate, upload a Root Certificate.
– Type values for EAP Identity, Login Name, and Password.
3. Click OK.
4. For the new settings to take effect, restart the printer.
5. Disconnect the printer from the wired network.
CCoonnffiigguurriinngg tthhee PPrriimmaarryy NNeettwwoorrkk FFrroomm tthhee EEmmbbeeddddeedd WWeebb SSeerrvveerr
You can set the primary network connection type in the Embedded Web Server.
Note:
• A Primary Network setup in the Embedded Web Server is possible only if the optional Wi-Fi
connection kit is installed and enabled.
• By default, without a Wi-Fi connection, the primary network is set to Ethernet. When the kit
is installed and enabled, the device acquires two network connections. One network
connection is primary, and the other network connection is secondary.
• The following features are available only over the primary network connection:
– IPsec
– SMTP
– SNTP
– WSD scan
– Scan to SFTP, Scan to SMB, Scan to Email
– LDAP
– UPnP discovery
– ThinPrint
– EIP Web Service
• If you remove the Wi-Fi connection module, the primary network connection is set to
Ethernet.
1. In the Embedded Web Server, log in as a system administrator, then click Connectivity.
2. In the Connections area, click Ethernet.
3. In the Common area, click Edit.
4. Click Primary Network, then select the appropriate network connection type for the device.
Xerox
®
Phaser
®
6510 Printer
User Guide
155
System Administrator Functions