User's Manual

Symptom
Probable Causes Solutions
• Page Margins Are Inconsistent.
• The image is not centered on
the page or the margins are
not consistent.
A paper registration adjustment is
needed.
Use the paper registration
procedure to adjust the image
position on the page. For details,
refer to Adjusting Paper
Registration.
Faded printouts with multiple
colors faded.
The toner cartridges are not
Xerox
®
toner cartridges.
Verify that the toner cartridges
meet specifications, and replace
them if necessary.
The paper being used is outside
the recommended specification
range.
Replace the paper with a
recommended size and type, and
confirm that your control panel
and print driver settings are
correct. For details, refer to
Supported Paper.
The paper type is heavier or
thicker than the paper type
selection.
• Ensure that the proper paper is
loaded in the paper tray.
• Choose a heavier paper type at
the control panel and in the
print driver.
• Use a lighter paper or paper
type.
The bias transfer voltage is not
properly adjusted for the paper
type.
Verify that the paper types set in
the control panel and the print
driver match the paper loaded in
the tray.
The settings in the application or
print driver are incorrect.
Print the Demo Page. For details,
refer to Printing Reports. If the
Demo Page looks correct, the
printer is printing properly. Verify
that the application and the print
driver selections are correct for
your print job.
The paper is damp. Replace the paper.
The high-voltage supply is
defective.
For assistance, go to the Xerox
®
Support website at www.xerox.
com/office/6510support.
144
Xerox
®
Phaser
®
6510 Printer
User Guide
Troubleshooting