User Manual

System Administrator Functions
174 Xerox
®
Phaser
®
6510 Color Printer
User Guide
Configuring the Output Settings
You can use this menu to configure printer output settings.
To enable printing the user ID on the output page:
1. At the printer control panel, press Menu.
Note: To navigate through the menu, use the arrow buttons. To select a menu item, press OK.
2. Navigate to Admin Menu, then press OK.
3. Navigate to Printer Settings, then press OK.
4. To configure the device to print the user ID on the output page, navigate to Print User ID, then
press OK.
5. To select a setting, press the arrow buttons, then press OK.
6. To return the printer to Ready, press Menu.
To configure banner page settings:
1. At the printer control panel, press Menu.
Note: To navigate through the menu, use the arrow buttons. To select a menu item, press OK.
2. Navigate to Admin Menu, then press OK.
3. Navigate to System Settings, then press OK.
4. To specify if a banner page is printed, navigate to Banner Settings, then press OK.
5. Navigate to Banner Sheet, then press OK.
6. To select an option, use the arrow buttons:
− Off: This option directs the printer not to print a banner pages.
− Start Sheet: This option directs the printer to insert a banner page before the first page of
each print job.
− End: This option directs the printer to insert a banner page after the last page of every print
job.
− Start and End: This option directs the printer to insert a banner pages before the first page and
after the last page of every print job.
7. Press OK.
8. To return the printer to Ready, press Menu.
To configure the banner page tray settings:
1. At the printer control panel, press Menu.
Note: To navigate through the menu, use the arrow buttons. To select a menu item, press OK.
2. Navigate to Admin Menu, then press OK.
3. Navigate to System Settings, then press OK.
4. Navigate to Banner Settings, then press OK.
5. To select the tray from which the banner page is printed, navigate to Banner Tray, then press OK.
6. To select a tray, press the arrow buttons, then press OK.
7. To return the printer to Ready, press Menu.