User's Manual

Guide to Printing Using Xerox Production Print Services 6-1
6 Using Command Line
Client
The Xerox Document Submission Command Line software
enables you to set up and submit print jobs by entering
commands in a DOS or Unix window, from a PC or Sun
workstation. This chapter describes the procedure and syntax
for entering the print and job setup commands.
To view more of the window or enable the scroll bars, right
click on the title bar for the Command Prompt window and
then select [Properties...]. Change the WIndow size to
Width=100 and Height-100. Select [OK]. Apply properties to
the current window only and select [OK]. Scroll bars should
appear on the right of the window.
Accessing the XDS Command Line software
The XDS Command Line software is installed as part of the
process of installing XDS Plus. Refer to the Installation Guide
for information on installing XDS Plus and all its components.
Accessing XDS Command Line from Windows
To open XDS Command Line from Windows, follow these
steps:
1. Log on to your network.
2. From your workstation , open a command line prompt
(such as DOS) and navigate to the install directory.
The XDS Command Line DOS window opens, displaying the
XDSCL> prompt. You are now using XDS Command Line in
Multiple Command Mode and and may enter job setup and
print commands on the command line at this prompt.