User guide

Troubleshooting
Xerox WorkCentre 5735/5740/5745/5755/5765/5775/5790
General Care and Troubleshooting
285
Paper Curls • Load the paper in the paper trays with the seam side of the paper up.
Load the paper in the Bypass Tray with the seam side down.
• Load non-standard media in the Bypass Tray.
• If the paper curls excessively, flip the paper over in the applicable paper
tray.
The Finisher does not stack the
output correctly
• Unload the finisher tray frequently.
• Do not remove stapled sets while the finisher is compiling.
• Check the paper tray guides are locked into position against the paper.
• When using large paper, remove any output contained in the Stacker
Tray.
• Load the paper in the paper trays with the seam side of the paper up.
Load the paper in the Bypass Tray with the seam side down.
• Load non-standard media in the Bypass Tray.
• If the paper curls excessively, flip the paper over in the applicable paper
tray.
• Check the correct paper size has been selected for the paper loaded in
the tray.
The Finisher does not staple or
hole punch correctly
• To correct stapling problems, ensure the maximum number of sheets is
not exceeded for the finisher being used.
• The maximum number of sheets when stapling heavyweight paper is
determined by the finisher type. The Basic Office Finisher staples 12
sheets of heavyweight paper, the Advanced Office Finisher staples 20
sheets of heavyweight paper, and the High Volume Finisher staples 30
sheets.
• Check the correct option has been selected on the touch screen.
• Check the touch screen for a fault message indicating no staples.
Replace the staple cartridge.
• When using large paper, remove any output contained in the Stacker
Tray.
• Check that the Chad Bin is not full. The Chad Bin collects waste from the
hole punch.
• Check the correct paper size has been selected for the paper loaded in
the tray.
• Check the paper tray guides are locked into position against the paper.
Stray marks or black marks
from hole punched originals are
not removed
•Use the Edge Erase option to erase the edge with the punched holes.
Refer to Edge Erase on page 48 of Copy.
• Copy from the document glass with the document cover or document
feeder down.
Images are out of sequence or
upside down when the Booklet
Creation feature is used
• Ensure that the originals are in the correct sequence.
• Feed LEF originals to SEF orientated paper.
• Enable the display options for Booklet Creation and ensure that the
correct sequence is selected (i.e. Left to Right or Right to Left).
The output is blank • Ensure the originals are loaded either face up in the document feeder or
face down on the document glass in the top right position.
Problem Potential Solution