User guide

Copy Options
Xerox WorkCentre 5735/5740/5745/5755/5765/5775/5790
Copy
42
Using the Booklet Creation - On option the device will scan your originals and automatically reduce and
arrange the images in the correct sequence on your selected media, so that a booklet is created when
the copy set is folded in half. A cover can be inserted onto the booklet automatically, refer to Covers on
page 50.
The options are:
Booklet Creation
• Off select this option if you want your output layout to
match your originals. For example, if your originals are
already in a booklet layout.
• On select this option if you want the device to
automatically reduce and arrange the images to
create a booklet layout.
Finishing
• Folded & Stapled will staple and fold the output along the center margin to produce booklets.
• Fold Only will fold the output along the center margin to produce booklets.
• None select this option if you do not want the device to fold and staple your output.
Tri-Folded
If the optional Tri-fold Module is installed on your device, a single sheet of A4 or 8.5x11” media in a
weight range of 60 to 120 gsm (16 to 32 lb) can be folded in a C Fold or Z Fold. Originals must always
be loaded Short Edge Feed (SEF).
• C Fold the page will be folded as shown. Select
Collated for sets or Uncollated for stacks.
• Z Fold the page will be folded as shown. Select
Collated for sets or Uncollated for stacks.
Finishing Devices
Finishing Device Description
Basic Office Finisher • Holds up to 250 sheets of paper in the Top Tray, and up to 1000 sheets
in the Stacker Tray.
• Paper weight 60 to 216 gsm (16 to 57 lb).
• The Stacker can collate, stack and staple your output, depending on the
features selected. It staples between 2 and 30 sheets of 80 gsm (20 lb)
paper, less if using heavyweight paper or tabs.
• The staple cartridge for the Basic Office Finisher contains 3000 staples.
Note: Double Staple is not available with the Basic Office Finisher.