User guide

Network Settings
Xerox WorkCentre 5735/5740/5745/5755/5765/5775/5790
Administration and Accounting
265
Network Settings
These settings are used to enter the network parameters
for the system. This section provides an overview of the
options available.
Detailed instructions for network installation are provided
in the System Administrator Guide.
Network Setup
These options are used by the System Administrator to configure the network settings. Network
settings for TCP/IP, Microsoft Network, Apple Talk and Netware can be configured.
Online/Offline
Use to disconnect the device from the network temporarily. Selecting Offline disconnects the device
from all networks. Any job entering the system is held. Any current outgoing jobs are not completed
while the system is offline.
Select Online reconnect the device to the network.
Ethernet Physical Media
The Ethernet Physical Media option is used to set the speed of your network. The device supports the
following selectable speeds:
•Auto
• 10Mbps Half-Duplex
• 10Mbps Full-Duplex
•100 Mbps Half-Duplex
• 100 Mbps Full-Duplex
• 1 Gbps Half-Duplex.
• 1 Gbps Full-Duplex
802.1x
The device supports 802.1x authentication based on the Extensible Application Protocol (EAP). 802.1x
Port Based Network Access Control is used to ensure that devices that are connected to the network
have the proper authorization. The 802.1X configuration is used to authenticate the device rather than
an individual user. After the device has been authenticated, it will be accessible to users on the
network.