Datasheet
18 XEROX
®
D110/ D125 COPIER-PRINTER CED
11. Production Speeds
The rated speed for the Xerox
®
D110 Copier-Printer and Xerox
®
D125 Copier-Printer are 110 and 125 pages per
minute, respectively. These speeds are achievable in optimum conditions using Letter/A4 sized media, long edge
feed, and discounting startup delays like warm-up time and time to clear the paper path. Use of finishing features,
multiple paper trays and other factors affect the productivity of all printing devices to some degree.
The output speed of a print job is affected by:
• Use of finishers and finishing features (e.g., stapling, hole punch, folding, and Booklet Maker will
slow down print speed)
• Job length
• Using the Bypass Tray or High Capacity Feeder
• Single-sided versus two-sided job
• The time it takes to RIP a job based on the type of PDL
• Other factors outside the control of the product
11.1. Print Speed-
Print per Minute (PPM) of the print engine using a common configuration is defined as below.
Timing of throughput is measured with one original by the time taken after the trail edge of the 1st sheet is
fed until the trail edge of the 11th sheet is output to the top tray. Throughput is measured using the
system trays (1,2,3,4) and the High Capacity Feeder (HCF) Option (6,7) with output to the top tray.
Paper Size
125
ppm
Simplex
125 ppm
Duplex
*3
110 ppm
Simplex
110 ppm
Duplex
*3
B5 LEF 125 125 116 105
A4 LEF / 8.5x11 LEF 125 125 110 100
*2
B5 SEF / A4 SEF / 8.5x11 SEF
*1
88 80
*2
78 70
*2
B4 SEF / 8.5x14 / 8.5x13 SEF
*1
78 70
*2
69 69
A3 SEF / 11x17 SEF
*1
62 62 55 55
12 x 18 SEF / 12 x 19.2 SEF
*1
34 34 34 34
Note 1: Only Tray 3, Tray 4 or Oversized High Capacity Feeder (OHCF) may be used.
Note 2: For second output sheet onward, IPM (Impressions Per Minute) is equal to the CPM
(Copies Per Minute) in simplex printing.
Note 3: IPM: Impression per Minutes
Automatic Tray Switching (Load-While-Run)
The paper trays support Load-While-Run operation. If a tray in operation runs out of stock, and another
tray with the same programmed stock is available and loaded, the system will automatically switch to the
new tray when the first runs out. The operator may then open the empty tray and reload it without the
system stopping.