Datasheet

XEROX
®
D110/ D125 COPIER-PRINTER CED 3
2.8. Optional High Capacity Stacker with rollaway cart
• 5,000-sheet offsetting output stack tray; 7.2" x 8.3" up to 13" x 19.2" (B5 LEF to SRA3) (20 lb. Bond or
75 gsm)
• 500-sheet top tray (20 lb. Bond or 75 gsm)
• Includes one rollaway cart; additional carts available
2.9. Optional Folder
• C-fold and Z-fold of 8.5" x 11"/A4 (three equal size panels)
• Print on inside or outside of folded paper
• Folds 11" x 17"/A3 Z-fold for insertion into letter/A4 document sets
o (Engineering Z-fold) , 8.5”x11”/A4 final size
• Paper weights range: 60 gsm - 90 gsm
2.10. Optional SquareFold
®
Trimmer Module
All settings and selections must be made at the user interface or from any of the print drivers.
 Minimum Paper Size is 8.5” x 11” / A4 Short Edge Feed (SEF)
 Maximum Paper Size is 13” x 18” (330 mm x 457 mm)
 Paper weights usage is 60 gsm - 253 gsm (papers above 105gsm as cover)
 Booklet size and trim capacity
• @ 90 gsm (24 lbs) is 5 - 20 sheets or 20 - 80 booklet pages
• @ 80 gsm (20 lbs) is 5 - 25 sheets or 20 - 100 booklet pages
 Cut amount 2 mm (0.078 inches) - 20 mm (0.78 inches) adjustable in 0.1 mm increments.
Notes: Trim settings less than 2 mm (0.078 in.) may result in inconsistent trim quality and trim settings
greater than 20mm (0.78 in) will result in no trim to the booklet edge.
The covers may only be opened when a jam/fault occurs within the SquareFold® Trimmer Module. The top
covers will not open during normal operation or when the machine is idle.
Booklets exiting/leaving the SquareFold® Trimmer Module may contain trim remnants/scraps from the
previously trimmed booklet. This is due to static electricity build-up and is normal. If booklets contain trim
remnants/scraps, simply remove and discard them.
2.11. Optional GBC
®
AdvancedPunch™
• Our new offering is an in-line punch unit with a variety of optional die set patterns to combine printing,
collating and punching. Two (2) base GBC
®
AdvancedPunch™ are available for letter and A4 document
sizes depending on your country of origin. These two (2) configurations are similar but differ to
accommodate power and paper size.
• The GBC
®
AdvancedPunch™ is fully integrated with both the UI and the DFE's. It may be activated
from either the touch panel UI or from the DFEs. It has both a Bypass Mode and Punch Mode.
• There are currently several optional interchangeable Die Sets available for this unit. One Die Set will
come with the GBC® AdvancedPunch™. The 19-hole CombBind comes standard with the US letter
Modules. The 21-hole CombBind comes standard with the A4 Module. Additional die set may be
purchased (as shown in table below). Each die set has a 90 day warranty from date of purchase.
Warranties will be handled through the normal supplies channel. Dies replaced under warranty will be
warranted for the remainder of the period for the die being replaced. Failure to properly oil the die set
and continuous use of heavy weight and glossy paper may result in reduced die set life.