User guide
Table Of Contents
- Table of contents
- Introduction
- System overview of the 4635 LPS
- Using the PC UI
- Paper facts
- System control tasks
- Job control tasks
- Online printing tasks
- Offline printing tasks
- UNKNOWN
- Power on the open-reel tape drive
- Load an open-reel tape
- Load an open-reel tape by hand
- Unload an open-reel tape
- Unload an open-reel tape during a power failure
- Handle open-reel tapes
- Power on the 18 track 1/2 inch cartridge tape drive
- Unload a 1/2 inch cartridge
- Power off the 18/36 track 1/2 inch tape drive
- Handle cartridge tapes
- Load a 1/4 inch cartridge tape
- Handle 1/4 inch cartridge tapes
- Load a floppy disk
- Handle floppy disks
- Start an offline print job
- Rewind/unload tape
- Space
- Move
- UNKNOWN
- HIP printing tasks
- Status and print tasks
- File control tasks
- Maintenance tasks
- Precautions you should take
- Cleaning supplies
- Maintaining the printer
- Replacing the dry ink cartridge
- Replacing the dry ink waste container
- Adding fuser agent
- Cleaning the sensors and the reflecting surfaces
- Tape drive cleaning schedule
- Cleaning precautions—READ BEFORE CLEANING
- Cleaning procedures
- When to clean the tape drive
- Cleaning procedures
- How to clean the floppy disk drive
- Installing the custom transfer assist blade
- Setting tray size with the custom transfer assist blades
- Problem solving tasks
- LPS problems
- Printing problems
- Paper jams
- Incorrect paper size message
- Stacker bin problems
- System controller problems
- Tape drive does not perform self-load routine
- “OK” appears on the tape drive message display, but the loading door is closed
- Basic recovery procedure
- Initial program load (IPL) procedure fails
- You cannot insert a cartridge
- Tape does not unload
- Unloading a cartridge after a power failure
- Tape winds completely out of cartridge
- Message display is blank
- Tape drive does not become ready
- LPS problems
- MICR operating procedures
- Bar code operating procedures
- A. Meter reading and reporting
- B. Supplies
- Glossary
- Index
SYSTEM CONTROL TASKS
Figure 4-7. Information window (system rollover)
3. Vary the LPS offline from the host and either select the 'C'
header button or enter “C” in the Messages window.
Another message appears telling you that the system is
reloading the software.
4. After the software is reloaded, the following confirmation
window appears, asking if abort data should be printed for
later analysis.
Figure 4-8. Confirmation window (print abort data)
5. Select Yes or No, as appropriate.
6. Another confirmation window appears asking if you want to
recover jobs.
Figure 4-9. Confirmation window (auto job recovery)
7. Select Yes or No, as appropriate.
System rollover message through
system controller terminal (non-U.S.
markets only) If you are running the printer online, the system controller
display shows the following message:
OS2575 SYSTEM ROLLOVER. VARY OFFLINE FROM HOST. ENTER 'C'
1. Enter “C” to initiate the recovery procedure. With either
online or offline mode, the following messages are displayed:
4-8 XEROX 4635 LASER PRINTING SYSTEM OPERATOR GUIDE