User guide
Table Of Contents
- Table of contents
- Introduction
- System overview of the 4635 LPS
- Using the PC UI
- Paper facts
- System control tasks
- Job control tasks
- Online printing tasks
- Offline printing tasks
- UNKNOWN
- Power on the open-reel tape drive
- Load an open-reel tape
- Load an open-reel tape by hand
- Unload an open-reel tape
- Unload an open-reel tape during a power failure
- Handle open-reel tapes
- Power on the 18 track 1/2 inch cartridge tape drive
- Unload a 1/2 inch cartridge
- Power off the 18/36 track 1/2 inch tape drive
- Handle cartridge tapes
- Load a 1/4 inch cartridge tape
- Handle 1/4 inch cartridge tapes
- Load a floppy disk
- Handle floppy disks
- Start an offline print job
- Rewind/unload tape
- Space
- Move
- UNKNOWN
- HIP printing tasks
- Status and print tasks
- File control tasks
- Maintenance tasks
- Precautions you should take
- Cleaning supplies
- Maintaining the printer
- Replacing the dry ink cartridge
- Replacing the dry ink waste container
- Adding fuser agent
- Cleaning the sensors and the reflecting surfaces
- Tape drive cleaning schedule
- Cleaning precautions—READ BEFORE CLEANING
- Cleaning procedures
- When to clean the tape drive
- Cleaning procedures
- How to clean the floppy disk drive
- Installing the custom transfer assist blade
- Setting tray size with the custom transfer assist blades
- Problem solving tasks
- LPS problems
- Printing problems
- Paper jams
- Incorrect paper size message
- Stacker bin problems
- System controller problems
- Tape drive does not perform self-load routine
- “OK” appears on the tape drive message display, but the loading door is closed
- Basic recovery procedure
- Initial program load (IPL) procedure fails
- You cannot insert a cartridge
- Tape does not unload
- Unloading a cartridge after a power failure
- Tape winds completely out of cartridge
- Message display is blank
- Tape drive does not become ready
- LPS problems
- MICR operating procedures
- Bar code operating procedures
- A. Meter reading and reporting
- B. Supplies
- Glossary
- Index
Table of contents
Laser safety iii
Ozone information iii
Operation safety iii
Notice iv
Related publications v
Introduction xvii
About the reference set xvii
4635 Laser Printing System documentation set xvii
About this manual xx
Document conventions xxi
1. System overview of the 4635 LPS 1-1
Base components 1-1
System controller components 1-2
System user interface 1-2
Operator control panel 1-3
1/4 inch cartridge tape drive 1-4
Printer components 1-4
Feeder trays 1-5
High-capacity stacker bins 1-7
Inverter 1-8
Sample tray 1-8
Purge tray 1-8
Printer control console 1-8
Attention light 1-11
Registration transport levers 1-11
Optional components 1-12
Optional system controller components 1-12
Peripheral cabinet 1-12
Open-reel tape drive 1-12
1/2 inch cartridge tape drive 1-13
Floppy disk drive 1-14
Optional printer components 1-14
Feeder/stacker 1-14
Bypass Transport Module 1-14
XEROX 4635 LASER PRINTING SYSTEM OPERATOR GUIDE vii