User guide
Table Of Contents
- Table of contents
- Introduction
- System overview of the 4635 LPS
- Using the PC UI
- Paper facts
- System control tasks
- Job control tasks
- Online printing tasks
- Offline printing tasks
- UNKNOWN
- Power on the open-reel tape drive
- Load an open-reel tape
- Load an open-reel tape by hand
- Unload an open-reel tape
- Unload an open-reel tape during a power failure
- Handle open-reel tapes
- Power on the 18 track 1/2 inch cartridge tape drive
- Unload a 1/2 inch cartridge
- Power off the 18/36 track 1/2 inch tape drive
- Handle cartridge tapes
- Load a 1/4 inch cartridge tape
- Handle 1/4 inch cartridge tapes
- Load a floppy disk
- Handle floppy disks
- Start an offline print job
- Rewind/unload tape
- Space
- Move
- UNKNOWN
- HIP printing tasks
- Status and print tasks
- File control tasks
- Maintenance tasks
- Precautions you should take
- Cleaning supplies
- Maintaining the printer
- Replacing the dry ink cartridge
- Replacing the dry ink waste container
- Adding fuser agent
- Cleaning the sensors and the reflecting surfaces
- Tape drive cleaning schedule
- Cleaning precautions—READ BEFORE CLEANING
- Cleaning procedures
- When to clean the tape drive
- Cleaning procedures
- How to clean the floppy disk drive
- Installing the custom transfer assist blade
- Setting tray size with the custom transfer assist blades
- Problem solving tasks
- LPS problems
- Printing problems
- Paper jams
- Incorrect paper size message
- Stacker bin problems
- System controller problems
- Tape drive does not perform self-load routine
- “OK” appears on the tape drive message display, but the loading door is closed
- Basic recovery procedure
- Initial program load (IPL) procedure fails
- You cannot insert a cartridge
- Tape does not unload
- Unloading a cartridge after a power failure
- Tape winds completely out of cartridge
- Message display is blank
- Tape drive does not become ready
- LPS problems
- MICR operating procedures
- Bar code operating procedures
- A. Meter reading and reporting
- B. Supplies
- Glossary
- Index
SYSTEM OVERVIEW OF THE 4635 LASER PRINTING SYSTEM
Optional components
Optional components are available for both the system controller
and the printer.
Optional system controller components
The optional components for the system controller consist of:
• Peripheral cabinet
• Open-reel tape drive
• 1/2 inch cartridge tape drive
• Floppy disk drive.
Peripheral cabinet
The peripheral cabinet houses the open-reel and 1/2 inch tape
drives.
Figure 1-11. Peripheral cabinet with tape drives
1. Open-reel tape drive
2. 1/2 inch cartridge tape drive
Open-reel tape drive
The open-reel tape drive has the following features:
• 1/2 inch/13 mm streamer with a horizontal tape path.
• Self-loading tape system.
• Tape is visible through a window in the front of the tape
drive so you can verify the presence of the tape and tape
motion.
• The tape cover can be raised for routine cleaning.
• It has a control panel including an eight character
alphanumeric display for messages and error information.
1-12 XEROX 4635 LASER PRINTING SYSTEM OPERATOR GUIDE